Set Value Read; Hysteresis Set - Omron CQM1H series Operation Manual

Commands and Responses
Response

7-3-10 Set Value Read

Command
Command Code
Parameter
Response

7-3-11 Hysteresis Set

Command
Command Code
Parameter
If the wrong command code is set to the output word, the following error code will
be set to the input word.
E000: This error code will be set to the input word if a nonexisting command code
is used.
E002: Teaching command execution error
E003: This error code will be set to the input word if the mode designation for this
command is not correct.
This command is used to read a set value.
Parameters are not used with this command.
If the output word is set to the correct command code, the sign of the set value
and the set value will be set to the input word alternately in the following format.
If the output word is set to the wrong command code, the following error codes
will be set to the input word.
E000: This error code will be set to the input word if a nonexisting command code
is used.
This command is used to set the hysteresis.
If the input type data is changed, the hysteresis will be reset to its factory-set val-
ue.
The set data will be stored in the nonvolatile memory and will not be lost after the
Unit is turned OFF.
Section 7-3
Set value
0: LL
1: L
2: H
3: HH
Sign
0: Positive
F: Negative
Value
Range: 0 to 9999
Range: 0001 to 0999
Factory-set value: 0001
215