E2C-Ma11 Proximity Sensor Module - Omron CQM1H series Operation Manual

Switch Settings

2-2-2 E2C-MA11 Proximity Sensor Module

Cable Length Switches
Sensor
E2C-CR8A Position of the
E2C-CR8B switches of the
E2C-X1A Amplifier Unit
E2C-C1A
E2C-X1R5A
Timer Switch
Mode Selector
Set the switches as shown below to the length of sensor cable being used either
for standard cable lengths or after cutting the cable.
0 to 1 m
A C
B D
Knob
position
Note 1. If two cables of the same length and diameter are being attached together in
parallel, position one of the cables 1 m above or below the other.
2. Set all switches to the right for the E2C-CR5B.
Setting
0 ms
10 ms
The following is an example of a sensor output operation chart.
Sensing distance
Setting distance → 100%
Control output (OFF-
delay activated)
Control output
(OFF-delay deactivated)
Operation indicator
(orange)
Stability operation
indicator (green)
Note Set the switches on the side panel before mounting the Module to the Sensor
Unit.
Setting
RUN
SET
Note 1. Refer to 3-4-1 E3X-MA11 Optical Fiber Photoelectric Module for the fiber
lock lever of the E3X-MA11.
2. Refer to Section 4 Sensor Module Operation for details on the operation of
the mode selector and teaching button.
Cable length
1 to 2 m 2 to 3 m
A C A C
B D
B D
No timer
10-ms Off-delay timer active
Approx. 107%
Approx. 93%
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Normal operation
Sensitivity adjustment (teaching)
Section 2-2
3 to 4 m 4 to 5 m
A C A
B D B
Function
10 ms
h
Function
C
D
135