Screen & Door Frame Overlay Installation - Regency GEM54-NG Owners & Installation Manual

SCREEN & DOOR FRAME OVERLAY INSTALLATION
SCREEN AND DOOR FRAME OVERLAY INSTALLATION
Stainless must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damage after
installation will not receive consideration.
To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
Stainless will discolor a little during normal operation. This is normal and should not be considered a defect.
All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this may result in burn stains which you will be unable to remove. This is not a warranty item.
Warning: Turn off the unit by way of the wall switch or remote.
Allow unit to cool at least 10 min. - prior to removing
faceplate.
1) Orient the safety screen so the raised part of the screen faces up.
2) Place the screen into the back side of the door frame as shown
below.
3) Hold the screen in place in door frame as shown below -
install door frame with screen onto unit.
Regency Gemfire™ Gas Fireplace
918-827a
Before you start:
4) Install the door frame overlay by hooking the top fl ange over top of
the glass door, push in the bottom of the door frame overlay to secure
in place.
Glass Door
5) Door frame and screen installed on the Gemfi re 54.
6) Place 2 of the supplied magnets on the lower corners of the Door
Frame Overlay, this will keep the Faceplate in position after it has
been installed.
1
GEMFIRE 54
INSTALLATION
Screen
Door Frame
Overlay
Magnet Position
39
12/15/11