Regency GEM54-NG Owners & Installation Manual page 31

7) Loosen 6 screws that secure the burner extenders. on burner tray,
located behind the burner on either side of the pilot assembly.
8) Lift out the 2 burner tray extenders.
Burner tray extenders
9) After extenders have been removed. Remove the 2 screws that
secure the burner tray, at the base of the fi rebox.
10) Slide the burner to the left and lift it out.
Location of screws securing burner
918-798
Regency Gemfire™ Gas Fireplace
Burner tray extenders
Burner tray
Burner Bracket
11) With burner removed - lift out burner tray.
12) Pull off the pilot cap to expose the pilot orifi ce. (see below)
Pilot Orifi ce
13) Unscrew the pilot orifi ce with the Allen key and replace with the
LPG pilot orifi cein the kit and replace pilot cap (see below).
14) Remove burner orifi ce with a 1/2" wrench and discard. Use
another wrench to hold on to the elbow below
the orifi ce (see below).
15) Reinstall new burner orifi ce LPG stamped #51 or ULPG burner
orifi ce stamped # 52 and tighten.
2
GEM54
INSTALLATION
Pilot Cap
04/23/09
31