Wahl Z100 Instructions Manual page 14

MAINS CLIPPER
the hair, cutting only a small amount at a time.
3.Repeat around sides and back of head.
If you desire shorter hair, either change to a lower
number attachment comb, or apply more pressure
and less lift away from head with the present
attachment comb. This entire procedure requires
practice, it is always better to leave too much hair
the first few haircuts.
For the top of the head you will give a fairly short
cut if you use the #8 (2.5cm length) attachment
comb. With the teeth flat against the head, slowly
start trimming from the front to the back.
Longer hair on top: (no attachment comb). Use either
the enclosed barber comb, or a regular comb, and lift
the hair on the top of the head cutting over the comb, or
grasp the hair between the fingers from the front to the
back of the head, gradually cutting the hair shorter by
reducing the space between the comb or fingers and the
head. Comb the hair frequently, removing trimmed hair
and checking for uneven strands.
OUTLINING
When outlining, no attachment combs are needed. On a multi-cut
clipper, push the lever up to the close-cut position. Comb hair into
desired style, then starting between the ear and the sideburns as
shown, hold clipper with corner edge of blade against the hair-line.
Slowly follow the desired outline of the hair
over, around and behind the ears.
For defining sideburns and the back of the
neck, hold the clipper upside down, as shown,
and hold against the skin at the desired
length and move down. Comb hair and check
that sides are even. Check for uneven spots
throughout the haircut and amend if required.
14