Cutting Your Hair - Wahl Z100 Instructions Manual

f Hold appliance more flatly to the skin.
Cause: Gap between the front edge of the bottom blade and the front edge
of the top blade is not correctly aligned.
f Align the bottom blade (Fig. 7).
Appliance is not working.
Cause: Defective power supply.
f Make sure that contact between the appliance plug and the socket is
faultless. Check the mains cable for possible damage.
f Check the power supply.

CUTTING YOUR HAIR

(for average medium to long cut)
The first time you cut the hair, cut only a small amount until you
become accustomed to how long each attachment comb leaves the
hair. Always start by placing the largest attachment comb on the
clipper, then use shorter combs if desired length is shorter.
Remember, between professional haircuts, the hair grows evenly all
over the head and a light trimming at the lower neck and sides may
be all that is needed to bring that neat, well-groomed look.
Some kits do not include all WAHL attachment combs. However,
these combs may be available from your dealer, or can be found on
www.wahlstore.co.uk
For uniform cutting allow the clipper to cut its way through the hair.
Do not force it through at a faster rate.
1.Start by combing the hair so it falls into its
natural direction.
2.Place the largest attachment comb onto your
clipper and start by trimming the sides from
the bottom upwards. Hold the clipper lightly
against the hair with teeth of the attachment
comb pointing up but flat against the head.
Slowly lift the clipper up and outward through
MAINS CLIPPER
13