Wahl Z100 Instructions Manual page 10

MAINS CLIPPER
If your clipper has a power screw, it has been adjusted for peak efficiency
before leaving the factory. However, if the voltage in your home is low, you
may need to readjust it. To adjust power, first use the on/off switch to turn
appliance on, then use the plastic brush, a screwdriver or a thin coin to turn
power screw(E) in a clockwise direction until the arm strikes the coil, making
a noise (Fig. 3b). Then slowly turn power screw out (counterclockwise) just
until noise stops. This is the maximum power setting (Fig. 3a).
Cutting length adjustment
Cutting lengths for different models(not found in all models):
· Raise the adjustment lever – minimum cutting length (Fig. 4a).
· Lower the adjustment lever – maximum cutting length (Fig. 4b).
Cutting with attachment combs (depending on model)
The appliance can also be operated with attachment combs. Attachment
combs can be used to extend the cutting length range. Depending on
the model, different-sized attachment combs are included in the scope of
supply.
Accessories are available from your dealer.
Attaching/removing the attachment comb
f Set the adjustment lever to the shortest cutting length (Fig.
4b).
1. Place the attachment comb onto the cutting edge of the blade set and
press it down onto the blade set in the direction of the housing until it
clicks into position (Fig. 3a).
2. The attachment comb can be easily removed by lifting the hook in the
direction of the arrow (Fig. 5b).
Changing the blade set
Warning! Injuries and material damage due to incorrect
handling.
f Switch the appliance off and disconnect from the power supply
before changing the blade set.
10