Care And Cleaning - Wahl Z100 Instructions Manual

1. Switch the appliance off using the on/off switch (Fig. 2b) and disconnect
from the power supply.
2. Undo the screws on the blade set; remove the bottom blade and the
top blade (Fig. 7).
When assembling, the bottom blade and the top blade should be aligned
as follows:
f Set the adjustment lever to the shortest cutting length (Fig. 4a).
3. Place the top blade on the plastic cam (Fig. 8).
4. Position bottom blade and reinsert the two screws.
5. Before tightening the screws, align the bottom blade (Fig. 9).
Warning! Injuries due to incorrect handling.
f Align the bottom blade so that there is a gap of 0.5 mm to
1.0 mm between the front edge of the bottom blade and the
front edge of the top blade (Fig. 9)
f Baldfader clipper can be aligned as close as 0.2mm.
6. Tighten screws (Fig. 7).

CARE AND CLEANING

Danger! Electric shock due to penetration of liquid.
f Switch the appliance off and disconnect from the power supply,
before you start with cleaning and care.
f Do not immerse the appliance in water!
f Do not allow any liquid to get inside the appliance.
f Only reconnect the appliance to the power supply if it is
completely dry.
Handle with care! Danger from aggressive chemicals.
Aggressive chemicals could damage the appliance and
accessories.
f Never use solvents or scouring agents.
f Only use cleaning agents and blade set oil recommended by
the manufacturer.
Hygienic spray and blade set oil are available from your dealer or
our service centre.
MAINS CLIPPER
11