MAINS CLIPPER Please read all instructions carefully to familiarise yourself with your new Wahl Mains Clipper before using. Save these instructions for further reference. For any further assistance or information call Customer Services on T: 01227 740066 or visit W: www.wahl.co.uk E: customer.services@wahl.co.uk...
MAINS CLIPPER GENERAL USER INFORMATION Information about using the operation manual Before using the appliance for the first time, ► you must read and understand the operation manual completely. Consider the operation manual as part of the ► product and store it in a safe and accessible place.
MAINS CLIPPER Please retain this leaflet for future reference. IMPORTANT SAFEGUARDS When using your electrical appliance, basic safety precautions should always be followed, including the following: Intended use Only use hair clippers to cut human head hair. • Only use animal clippers to cut animal hair •...
Page 7
MAINS CLIPPER Use this appliance only for its intended ► purpose. Repairs to the appliance must only be carried ► out by a trained electrician in accordance with the electrical engineering regulations! Hazards Please adhere to the following safety instructions! Danger! Electric shock due to damage to appliance.
Page 8
MAINS CLIPPER Warning! Injuries due to incorrect handling Switch off the appliance and unplug from outlet ► when not in use, before putting on or taking off attachments and also before cleaning the appliance. Caution! Danger of product damage. Never use your appliance without paying ►...
2. Insert the appliance plug into the mains socket. 3. Switch on the appliance using the on/off switch (Fig. 2a) and, after use, switch it off again (Fig. 2b). Accessories are available from your dealer. Adjusting the power screw (Not found in all Wahl models)
Page 10
MAINS CLIPPER If your clipper has a power screw, it has been adjusted for peak efficiency before leaving the factory. However, if the voltage in your home is low, you may need to readjust it. To adjust power, first use the on/off switch to turn appliance on, then use the plastic brush, a screwdriver or a thin coin to turn power screw(E) in a clockwise direction until the arm strikes the coil, making a noise (Fig.
MAINS CLIPPER 1. Switch the appliance off using the on/off switch (Fig. 2b) and disconnect from the power supply. 2. Undo the screws on the blade set; remove the bottom blade and the top blade (Fig. 7). When assembling, the bottom blade and the top blade should be aligned as follows: f Set the adjustment lever to the shortest cutting length (Fig.
Page 12
MAINS CLIPPER f Remove the attachment comb (Fig. 5b) after every use. Remove the hair clippings from the blade set with the cleaning brush. f If a thorough cleaning is required, the blade set can be removed. See chapter Changing the blade set. f After cleaning the blade set, we recommend using hygienic spray.
Some kits do not include all WAHL attachment combs. However, these combs may be available from your dealer, or can be found on www.wahlstore.co.uk...
Page 14
MAINS CLIPPER the hair, cutting only a small amount at a time. 3.Repeat around sides and back of head. If you desire shorter hair, either change to a lower number attachment comb, or apply more pressure and less lift away from head with the present attachment comb.
Page 15
MAINS CLIPPER SHORT TAPERED STYLES If a short tapered cut on the sides and back is desired, please follow the following diagram: Starting with the desired attachment comb, cut from the back of the neck to the crown. Hold the attachment comb flat against the head and slowly move the clipper through the hair as shown.
Page 16
MAINS CLIPPER BALD FADE (Only applies to Baldfader Clipper) Your Wahl Baldfader Clipper is designed to allow you to create and maintain extremely close hair styles, such as the ‘Bald Fade’. Its fine-tooth, steel blades and powerful cool running motor give a close, smooth cut every time.
MAINS CLIPPER 6.To create a part, pick a spot off centre. Pull the scalp tight and with the end of the blade perpendicular to the head, move the clipper back and forth to cut a line. Comb through it and cut again to make sure the cut is precise.
UK. We would like to understand your product needs and expectations and we value any comments you may have. As part of Wahl Customer Care, we are offering you the chance to be kept up to date with the latest product launches, innovations and special offers.
Alternatively within the guarantee period you can return the product to Wahl (UK) Ltd who will repair any such defect or elect to replace the product or any part of it, without charge, provided there is proof of purchase.
Page 20
MAINS CLIPPER WAHL (UK) LIMITED HERNE BAY TRADE PARK SEA STREET HERNE BAY KENT CT6 8JZ. CUSTOMER SERVICES T: 01227 740066 www.wahl.co.uk Form No. Z100 Rev7 01-14...