Breville BES840XL Instruction Booklet page 14

PAGE hEAdER..... CARE & CLEAnInG
• If the steam wand remains blocked,
remove the tip using the integrated
spanner in the cleaning tool and soak
in hot water. Use the pin on the end of
the provided cleaning tool to unblock
the hole(s) before re-attaching to the
steam wand.
CLEAnInG thE fILtER BASKEtS
And PoRtAfILtER
• The filter baskets and portafilter
should be rinsed under hot water
immediately after use to remove all
residual coffee oils.
• If any of the holes in the filter basket
become blocked, use the pin on the
end of the provided cleaning tool to
unblock the hole(s).
• If the hole(s) remain blocked,
dissolve
a cleaning tablet in hot water and
soak filter basket and portafilter in
solution for approx. 20 minutes.
Rinse thoroughly.
CLEAnInG thE ShoWER SCREEn
• The group head interior and shower
screen should be wiped with a damp
cloth to remove any ground coffee
particles.
• Periodically purge the machine. Place
an empty filter basket and portfilter
into the group head. Press and hold
the 1 CUP button and run a short
flow of water to rinse out any residual
coffee.
CLEAnInG thE dRIP &
StoRAGE tRAy
• The drip tray should be removed,
emptied and cleaned after each use
(after the auto purge feature, see page
16) or when the drip tray indicator is
showing Empty Me!
26
• Remove grill from the drip tray. Wash
both in warm soapy water. The Empty
Me! indicator can also be removed
from the drip tray.
• The storage tray can be removed and
cleaned with a soft, damp cloth
(do not use abrasive cleansers, pads
or cloths which can scratch the
surface).
CLEAnInG thE oUtER hoUSInG
& CUP WARMInG tRAy
• The outer housing and cup warming
tray can be cleaned with a soft, damp
cloth. Polish with a soft, dry cloth. Do
not use abrasive cleansers, pads or
cloths which can scratch the surface.
notE
Do not use abrasive cleansers,
pads or cloths which can scratch
the surface. Do not clean any of
the parts or accessories in the
dishwasher.
USInG thE ALLEn KEy
Over time, the silicone seal surrounding
the
shower screen will need to be replaced to
ensure optimum brewing performance.
Press the POWER button to turn the
10.
machine Off and unplug the cord
from the power outlet.
Carefully remove the rear water tank
11.
and drip tray, taking particular care
if they are full.
Using a skewer or similar, clean
12.
the center of the screw of any
residual coffee.
Insert the shorter end of the Allen
13.
Key into the center of the screw.
Turn counter-clockwise to loosen the
screw.
CARE & CLEAnInG PAGE hEAdER.....
Once loosened, carefully remove
14.
and retain the screw, stainless steel
shower screen and black dispersion
plate. Make note of the side of the
shower screen and dispersion plate
that are facing downwards. This
will make re-assembly easier. Wash
the shower screen and dispersion
plate in warm soapy water, then dry
thoroughly.
Remove the silicone seal with your
15.
fingers or a pair of long-nose pliers.
Insert the new seal, flat side first, so
the ribbed side is facing you.
Re-insert the dispersion plate, then
16.
the shower screen, then the screw.
With your fingers, turn the screw
clockwise for 2-3 revolutions then
insert the Allen Key to tighten until
the screw is flush with the shower
screen.
Re-insert the drip tray and rear water
17.
tank.
Contact Breville Consumer Service or
visit www.breville.com for replacement
silicone seals or for advice.
27