Precor C354 Service Manual page 74

C534, C534i Self Powered Elliptical Fitness Crosstrainer
• 6. Remove two bolts, four washers and two nuts that fasten the ramp to the front ramp support.
7. Remove the ramp from the EFX.
8.
9.
10.
11.
12.
13.
14.
15.
•
Remove the two bolts at the lower end of the ramp support, remove the ramp support.
Set the replacement ramp support at its mounting position, fasten it to the frame base with
the bolts removed in step 8. Torque the bolts to 20 ft./Ib.
Set the replacement ramp in it's mounting position, replace the bolts washers and nuts
removed in step 5. Do tighten the bolts at this time.
Replace the four bolts and washers removed in step 4 that fasten the ramp to the rear ramp
bracket.
Torque the four bolts between the ramp and rear ramp bracket to 12 ft.llbs. Torque the two
bolts between the ramp and the front ramp support to 20 ft./Ibs.
Replace the ramp end cap with the screw removed in step 3.
Rotate both stairarms forward so that they are resting on the ramp.
Set the replacement right stairarm connector at its mounting position and slide the
secondary link onto the right stairarm connector. Replace, but do not tighten the hardware
removed in step 2. Torque the two bottom bolts to 50 in.llbs. Torque the horizontal bolt to 11
ft.lbs. Set the replacement left stairarm connector at its mounting position and slide the
secondary link onto the left stairarm connector. Replace, but do not tighten the hardware
removed in step 2. Torque the two bottom bolts to 50 in.llbs. Torque the horizontal bolt to 11
ft.lbs.
16. Replace the rear cover per Procedure 7.20.
17. Thoroughly, test the EFX per Section Four.
•
Page 74