Precor C354 Service Manual page 36

•
•
•
C534. C534i Self Powered Elliptical Fitness Crosstrainer
6. Securely tape one end of the replacement lower interconnect cable to the lower PCA end of
the existing lower interconnect cable. Carefully draw the existing lower interconnect cable
out of the front of the frame as you carefully feed the replacement cable into the access hole
near the lower PCA.
7. When the replacement interconnect cable emerges from the front of the frame, separate the
interconnect cables and discard the defective interconnect cable. Connect the replacement
interconnect cable to the lower PCA and mid-point connector. Rotate the lower PCA bracket
into it's mounting position and fasten it with the screws removed in step 5.
8. Replace the right and left rear cover sections and front frame end cap. Thoroughly, test the
unit per Section 4.
9. Remove the display housing per Procedure 7.1, steps 2 to 4. Set the display housing aside.
Disconnect the interconnect cable from the upper PCA. See Diagram 7.4. Remove the four
screws that fasten the display housing backplate to the main column. Remove the display
housing backplate.
10. Securely tape one end of the replacement lower interconnect cable to the upper PCA end of
the existing upper interconnect cable. Carefully draw the existing upper interconnect cable
out of the front of the frame as you carefully feed the replacement cable into the main
column.
11. When the replacement interconnect cable emerges from the front of the frame, separate the
interconnect cables and discard the defective interconnect cable. Connect the replacement
interconnect cable to the mid-point connector.
12. Feed the interconnect cable through the access hole in the display housing backplate and
fasten the display housing backplate to the main column with the screws removed in step 9.
13. Connect the upper interconnect cable to the upper PCA and fasten the display housing to
the display housing backplate with the screws removed in step 8.
14. Replace the red battery lead removed in step 1 and check unit operation as described in
Section Four.
Page 36