Precor C354 Service Manual page 71

•
C534, C534i Self Powered Elliptical Fitness Crosstrainerl
Procedure
7.26 -
Replacing a Power Input Jack Assembly
1. Remove the rear cover and disconnect the red battery lead from terminal M6 of the lower
PCA.
2. Disconnect the
J4
connector from the lower PCA. See Diagram 7.2 (C534) or Diagram 7.3
(C534i).
Diagram 7.26 - Power Input Jack Mounting
Reconnect the red battery lead, removed in step 1, to the positive (+) terminal of the battery.
Remove the power input jack mounting plate with the power input jack assembly from the
unit.
Remove the screws that fasten the power input jack mounting plate to the rear cover
support. See Diagram 7.26.
Input Jack
:-------;- Mounting Screw
Mounting Nut
Input Jack
Mounting Plate
Remove the nut that fastens the power input jack to the power input jack mounting plate.
Remove the power input jack from the power input jack mounting plate.
Fasten the replacement power input jack to the power input mounting with the mounting nut
provided with the power input jack.
Feed the power input jack wiring through the hole in the rear cover support and mount the
power input jack mounting plate with the screws removed in step 3.
Route the power input jack wiring to the lower PCA. Connect the plug on the power input
jack wiring to the J4 connector on the lower PCA.
•
3.
4.
5.
6.
7.
8.
9.
•
10. Replace the rear cover.
11. Check the operation of the EFX as described in Section Four.
Page 71