Table of Contents
Advertisement
3.1
Introduction
This chapter describes the unpacking of the DSU, cable connections depending on whether EIA-232-D or
ITU-T V.35 interface signaling is used on the data port, and how to configure the unit dependent on your site
situation. Once the DSU is configured, then the data port can be connected to your data device.
3.2
Unpacking
The shipping box contains the DSU, power adapter, and a documentation CD with a User's Guide. Inspect
the contents for signs of any shipping damage. If damage is observed, do not power up the unit, contact
Multi-Tech's Technical Support for advice (refer to Chapter 5 - Warranty). If no damage is observed, place
the DSU in its final location and verify the signal levels (EIA-232-D or ITU-T V.35) for the data port, and
connect your cables, phone lines, and power supply.
3.3
Telecom Safety Warnings
1.
Never install telephone wiring during a lightning storm.
2.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.
This product for use with UL and cUL listed computers.
4.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected
at the network interface.
5.
Use caution when installing or modifying telephone lines.
6.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electrical shock from lightning.
7.
Do not use the telephone to report a gas leak in the vicinity of the leak.
8.
To reduce the risk of fire, use only 26AWG or larger telecommunications cord.
Chapter 3 - Unpacking & Setup
16
Advertisement
Table of Contents
