AMX NXT-CV17 Operation/Reference Manual page 49

2.
Locate the edges of the two studs used in this installation. The location of the NXD is site dependant and
could involve notching more than one beam.
In this sample installation, the left beam is notched and the back box rests against the
right beam.
3.
Remove any screws/nails from the surface, along the notched beam, before beginning the cutout process.
4.
Follow procedures outlined within the Step 1: Removing the existing NXD Outer Housing section on
page 18 to carefully separate the Main LCD panel from the back box housing.
5.
Cut out the surface for the Wall Mount using the dimensions shown in FIG. 40.
FIG. 40 NXD-CV17 Wall Mount panel dimensions using #4 mounting screws
6.
Remove the magnetic faceplate/bezel (A in FIG. 41) from the main NXD unit (B in FIG. 41) by gripping
the faceplate and pulling with gentle outward force.
CV17 17" Modero Coor Video Touch Panels
Installation
39