Cv17 Touch Panel Accessories; Overview; Nxa-Avb Audio/Video Breakout Box (Fg2254-01); Product Specifications - AMX NXT-CV17 Operation/Reference Manual

CV17 Touch Panel Accessories

Overview

The following section outlines and describes the CV17 accessories (both the included and optional).

NXA-AVB Audio/Video Breakout Box (FG2254-01)

The A/V Breakout Box (FIG. 3) is designed to facilitate the installation and distribution of video, data, and
audio to Modero panels. The NXA-AVB accepts either Composite or S-Video from standard video output
devices and can be installed near other A/V equipment to allow distribution of audio/video and graphics to
panels located up to 200 feet (60.96m) from the source.
This breakout box can be mounted on either a horizontal flat surface or in an equipment rack (by using an
optional AC-RK Rack Kit).
Composite/
S-Video
Audio
FIG. 3 NXA-AVB A/V Breakout Box (front and rear views)

Product Specifications

NXA-AVB Specifications
Dimensions (HWD):
Power
Consumption:
Features:
Front Components:
Rear Components:
Included
Accessories:
CV17 17" Modero Coor Video Touch Panels
S-Video Chroma
Luma
In
Mic Out ICSNet In
• 1.50" x 5.55" x 4.88" (3.81 cm x 14.10 cm x 12.40 cm)
• Width when attached to mounting ears: 6.65" (16.89 cm)
• 50mA (with audio/video input)
• 23mA (with no audio/video)
• Routed through NXA-AVB using a PSN6.5 power supply.
• Accepts either Composite or S-Video (video-capable panels only)
• Provides audio distribution to the non-video touch panels over a CAT5 cable (up to
200 ft.)
• Provides video/audio distribution to the video-capable touch panels over CAT5 cable
up to 200 ft.(60.9 m)
• 2-pin 3.5 mm Phoenix connector for power to the touch panel
• RJ-45 connector that provides ICSNet signals to the touch panel
• RJ-45 connector that provides the differential audio and video signals to/from the
touch panel (panel type dependant)
• 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio
• 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio
• BNC connector (female) for Composite or Chroma (for video-capable panels only)
• BNC connector (female) for luminance (for video-capable panels only)
• RJ-45 connector for ICSNet input from the control system
• 2-pin 3.5 mm Phoenix connector for in-bound power
• Two 2-pin Phoenix connectors (41-5025)
• 4-pin Phoenix connector (41-5047)
• 6-pin Phoenix connector (41-5063)
• Rack Mount Kit (KA2250-40) with mounting bracket (62-2254-02)
CV17 Touch Panel Accessories
ICSNet (to panel)
Power In
(rear)
Power (to panel)
(front)
Audio/Video
(to panel)
5