AMX NXT-CV17 Operation/Reference Manual page 40

Installation
6.
Securely grasp both sides of the NXD panel (with LCD, MB-TP17 back box, and attached cables), rotate
the entire unit over, and lie it on a flat level surface.
7.
Note the available mounting contact surface area on the rear plastic cover (FIG. 32). This area represents
the space available for use with a VESA connector plate.
.83[21MM]
3.83[97MM]
4.06[103MM]
FIG. 32 MB-TP17 Mounting contact surface area
8.
Insert and secure the ten #6-32 securing screws into their pre-drilled holes along the edges of the NXD
unit (FIG. 31). This step secures the NXD unit to the rim of the rear plastic cover.
9.
Align a VESA mount connector (purchased separately) to the four #8-32 screw holes on the back of the
rear plastic cover (FIG. 32).
10.
Insert the four provided #8-32 screws through the VESA mount's four holes and then into the pre-drilled
holes on the rear plastic cover.
When installing a VESA mount to the rear plastic cover, use only the AMX provided
#8-32 screws.
11.
Secure these four #8-32 screws to the rear plastic cover by using a grounded Phillips-head screwdriver.
This step secures the VESA mount to the rear of the panel.
FIG. 33 Installation of grommet into the rear plastic enclosure
30
1.84[47MM]
Rear plastic cover (rear view)
Rim of the strain relief grommet
should lie flush against enclosure
CLIP FACING UP
VESA mount connection location
(USE ONLY AMX PROVIDED #8-32 screws)
CV17 17" Modero Coor Video Touch Panels