AMX NXT-CV17 Operation/Reference Manual page 45

Refer to the SP2256-11 engineering
drawing on www.amx.com for more
detailed framing information
Enough room must be left
for drywall clips to fold and
collapse above and below
the back box
Offset vertical beam
FIG. 37 NXD-CV17 framing installation overview
INSTALLER: LEAVE A GAP BETWEEN THE SURFACE OF THE STUD AND THE
BACK BOX MOUNTING RIDGE TO ACCOMMODATE THE DRYWALL/
SHEETROCK.
box has been mounted onto the beams.
2.
Locate the edges of the two studs used in this installation. The location of the NXD is site dependant and
could involve notching more than one beam.
In this sample installation, the left beam is notched and the back box rests against the
right beam.
3.
Remove any screws/nails from the drywall, along the notched beam, before beginning the cutout process.
4.
Cut out the surface for the NXD-CV17 Wall Mount using the dimensions shown in FIG. 38.
Be sure to cut out the four notches along the top and bottom areas to accommodate the four drywall
expansion clips (provided).
CV17 17" Modero Coor Video Touch Panels
With an existing wall in place, continue with steps 3 and 4 to notch one or both selected beams.
There is no horizontal support beam "framing" in this method.
Take into account the width of the cutting blade and the thickness of the drywall surface when
making the cut into the drywall.
This gap allows the installation of the drywall/sheetrock after the back
Installation
*
*
35