Mounting The Bottom V-Belt Guard; Fitting The Upper Belt Guard - Pfaff 337 Instruction Manual

Installation and commissioning
8

Mounting the bottom V-belt guard

.01.04
●
●
8

Fitting the upper belt guard

.01.05
20
4
3
Fig. 8 - 04
Loosen screws 2 and adjust belt guard support 1 so that the motor pulley and V-belt run
freely.
Tighten screws 2 and Fasten belt guard 3 with screw 4.
Fig. 8-04 shows a Quick-motor. If a different motor is used, follow the instruc-
tions of the Motor Instruction Manual.
1
4
5
Fig. 8 - 05
2
3
●
Screw stop piece 2 onto belt guard part 3.
●
Screw on belt guard part 3 onto the
2
housing.
●
Screw on belt guard part 4 onto the
housing.
●
Secure belt guard parts 5 and 6 onto the
table top.
6
1
109-071
If a large balance wheel is
used, the corner 1 of the belt
guard 3 must be broken out.
2