Hold Button; Flash Button; Call Waiting Display - Cortelco Colleague 2220 Owner's Instruction Manual

The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This
is particularly useful if you are connected to a PABX system where you must dial an
access code (usually the number 9) to obtain an outside line.
1. Press the PAUSE button once and release at any point in the dialing sequence
where a pause is desired.
2. The PAUSE button can be pressed more than once to create a longer pause.

HOLD BUTTON

1. To place a call on hold, press the HOLD button. The Line LED will then flash.
Press the Line button being used to release Hold.
2. To Answer a Call on the other line while speaking on one line. Place the current
line on hold. Press the ringing Line button, Line 1 or Line 2. If you want the
second call to join you in a three-way conference, press the CONF.
3. To Place both calls on hold press the Hold button and both lines will be on hold at
the same time. The Line/Hold LEDs will light. To cancel hold for only one line
press the desired line button (Line 1/2). The other line will remain on hold.

FLASH BUTTON

This telephone provides a break signal for a PABX service of Call Waiting from your local
telephone company. The Flash time is programmable from 100ms to 1000ms, in 50ms
increments. You can change the flash time in the setup procedure. The default Flash time
is 600ms. If you have Call Waiting service, you can alternate the Call Waiting function per
the following instructions.
1. While having a conversation, another party calls and you hear a tone.
2. Press the FLASH button once and release. The first conversation is placed on
hold and the second call can be answered.
3. Press FLASH button again and release. The first caller can be spoken to again
and the second call is placed on hold.
Note : If you also have subscribed to Call Waiting Caller ID service, please see Call
Waiting Display below

CALL WAITING DISPLAY

In the past, if you had call-waiting service, a tone alerted you there was a new call
coming while you were on an existing call. Now our Call Waiting Caller ID not only tells
you there is another call waiting, but lets you know who the caller is before you answer
it. The call waiting information is shown on the unit's display. The CALL WAITING (CW)
symbol will flash for 16 seconds along with the telephone number and name of the
person who is on call waiting. Press the FLASH button to put the existing call on hold
and answer the new call.
No matter whether you answer the call or not, the Call Waiting Caller ID will store the call
information for future reference.
10