Step 4: Installing Anti-Tip Device - Thermador PD304 Installation Instructions Manual

PD30 and PD36 Dual Fuel Ranges (Figures 8A and 8B)
Thermador Service Part No.
415078
487310
IMPORTANT INSTALLATION
INFORMATION:
• The anti-tip bracket may be attached to a solid wood
cabinet having a minimum wall thickness of 3/4".
• The thickness of the wall or floor may require use of
longer screws, available at your local hardware store.
• In all cases, at least two (2) of the bracket mounting
screws must be fastened to solid wood or metal.
• Use appropriate anchors when fastening the mount-
ing bracket to any material other than hardwood or
metal.
• Prepare holes at fastener locations as identified be-
low:
- For walls, wall studs, or floors composed
of solid wood or metal, drill 1/8" pilot holes.
Figure 8A - Mounting Anti-tip Bracket
Figure 8B

Step 4: Installing Anti-Tip Device

2-1/2"
(typical -
either side)
Qty Description
4 Screw, Phillips, #10 x 1-1/2"
1 Anti-Tip Bracket, Floor-Mounted
- For walls or floors composed of drywall, sheet-
rock or other soft materials, drill 3/16" holes to
a minimum depth of 1-3/4", then tap plastic
anchors into each of the holes using a hammer.
- For walls or floors composed of concrete or
concrete block, drill 3/16" holes to a minimum
depth of 1-3/4", then tap concrete anchors into
each of the holes using a hammer.
- For walls or floors having ceramic tile covering,
drill 3/16" holes through the tile only, then drill
into the material behind the tile as indicated
immediately above.
• If the range is moved to a new location, the Anti-Tip
Device must be removed and reinstalled.
MOUNTING ANTI-TIP BRACKET
The alternative floor mounted bracket shall be
installed as follows:
a) Place bracket on floor in position shown in
Figure 8B.
b) Secure to floor or wall stud.
c) Later, when the unit is installed,the adjustable
leg will slide under the bracket.
Page 13
from edge of range
2-1/2"