Wds - Draytek Vigor 2110 Series User Manual

Enable WPS
WPS Status
SSID
Authentication Mode
Configure via Push Button
Configure via Client PinCode
4 . 1 3 . 6 W D S
4 . 1 3 . 6 W D S
WDS means Wireless Distribution System. It is a protocol for connecting two access points
(AP) wirelessly. Usually, it can be used for the following application:
Provide bridge traffic between two LANs through the air.
Extend the coverage range of a WLAN.
To meet the above requirement, two WDS modes are implemented in Vigor router. One is
Bridge, the other is Repeater. Below shows the function of WDS-bridge interface:
Vigor2110 Series User's Guide
Check this box to enable WPS setting.
Display related system information for WPS. If the
wireless security (encryption) function of the router is
properly configured, you can see 'Configured' message
here.
Display the SSID1 of the router. WPS is supported by
SSID1 only.
Display current authentication mode of the router. Only
WPA2/PSK and WPA/PSK support WPS.
Click Start PBC to invoke Push-Button style WPS setup
procedure. The router will wait for WPS requests from
wireless clients about two minutes. The WPS LED on the
router will blink fast when WPS is in progress. It will
return to normal condition after two minutes. (You need to
setup WPS within two minutes)
Please input the PIN code specified in wireless client you
wish to connect, and click Start PIN button. The WLAN
LED on the router will blink fast when WPS is in progress.
It will return to normal condition after two minutes. (You
need to setup WPS within two minutes)
177