Miele KM 6388 Operating And Installation Instructions page 46

Problem solving guide
Problem
The food in the pan
hardly heats up or does
not heat up at all when
the Auto heat-up func‐
tion is switched on.
A noise can be heard
after the appliance is
switched off.
One or several residual
heat indicators is flash‐
ing.
The sensor switches
show increased sensi‐
tivity or fail to react.
46
Possible cause and remedy
There is too much food in the pan.
 Start cooking at the highest power setting and
then turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pan which is better able to conduct
heat on an induction cooktop.
The fan will continue running until the appliance has
cooled down. It will then switch itself off automatical‐
ly.
There was a power failure during operation or when
residual heat was present.
You accessed the programming function while residu‐
al heat was still present.
The sensitivity level of the sensor switches has
changed.
 Make sure that there is no direct light (from the
sun or from an artificial source) falling onto the
cooktop. The area surrounding the cooktop must
not be too dark.
 Make sure that there is nothing covering the sen‐
sors or the cooktop.
Take any pans off the cooktop and wipe away any
food deposits.
 Interrupt the power supply to the cooktop for ap‐
prox. 1 minute.
 If the problem persists after power is restored,
please contact Miele.