Miele KM 6388 Operating And Installation Instructions page 45

Problem
After switching the
cooktop on,  appears
in the timer display for
several seconds.
 flashes in the timer
display and the cooktop
switches off automati‐
cally.
After switching on the
cooktop,  appears in
the timer display for
several seconds. The
cooking zones do not
heat up.
A cooking zone
switches itself off auto‐
matically.
A cooking zone or the
whole cooktop
switches off automati‐
cally.
The Booster has auto‐
matically switched off
early.
The cooking zone is not
working in the usual
way on the power set‐
ting selected.
Power setting 9 is auto‐
matically reduced if you
select power setting 9
on two linked cooking
zones or extended
zones at the same time.
Possible cause and remedy
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
"System lock / Safety lock").
One or several of the sensors are covered, for exam‐
ple, by finger contact, food boiling over or by an ob‐
ject such as an oven glove or tea towel.
 Remove the obstruction and/or clean the cooktop
(see "Safety switch-off").
The cooktop is in demonstration mode.
 You need to deactivate Demonstration mode (see
"Programming").
A cooking zone might have been operated for too
long.
 You can use the cooking zone again by switching
it back on (see "Safety switch-off").
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
Operating both zones at power setting 9 would ex‐
ceed the permitted maximum power for the cooktop.
 Use another cooking zone which is not linked.
Problem solving guide
45