Panasonic DP-C405 Service Handbook page 442

No. Parameter
068 NYSE Fax
Forward
(USA and
Canada Only)
069 NYSE Local Print
(USA and
Canada Only)
070 Line Error
071 Total Error
072 Continuous Error Off
073 Error Detect
074 RTN Receive
075 Coding
076 Batch TX
(USA and
Canada Only)
077 RX JAM Length
078~ Not Used
079
080 Original Lead
Edge ADF
081 Original Tail Edge
ADF
082 JAM Length
083 Not Used
Ver. 1.1
Function Parameter Table
Selections
Off
On
Inc
On (Always)
128 lines
256 lines
512 lines
1024 lines
2048 lines
Off (will not disconnect
line)
5
10
15
20
3
6
12
Lines
Rate
Discon
Conti
MH (MH only)
MR (MH or MR)
MMR (MH, MR, or MMR)
JBIG (MMR, MR, MH, or
JBIG)
Off
On
Off (unlimited)
2 m
-99
~
+99
-99
~
+99
1 m
2 m
Selects whether the machine will forward the
incoming, and outgoing faxes to a specified station.
Note:
Once this parameter is activated, Fax Forwarding
via Fax Parameter No. 054 is automatically
disabled, an Access Code of "0000" is
automatically assigned and Fax Parameter No.
038 has a new setting added called "NYSE".
Selects the printing condition for the incoming faxes
after FAX Forwarding.
INC. : Prints only if FAX Forwarding fails.
ON : Always prints.
1. Selects the line disconnect condition during
reception. If the number of line errors exceed this
setting, the unit will disconnect the line.
2. Selects the transmit condition of RTP/PIP, or RTN/
PIN.
(Available if No. 73 Error Detect is set to "LINES")
(See Note 2)
Selects the transmit condition of RTP/PIP, or RTN/
PIN.
(Available if No. 73 Error Detect is set to "RATE".)
(See Note 3)
Selects the continuous total error criteria of Off/3/6 or
12 lines in Standard mode. If continuous total error
exceeds this setting, the unit will transmit RTN/PIN.
(Available if No. 73 Error Detect is set to "RATE".)
Selects the error detect condition Lines/Rate.
Selects whether to disconnect the phone line, or to
continue when "RTN" is received.
Selects the coding scheme.
Selects whether the batch transmission is available.
Selects the maximum length of a received document
that can be printed.
Adjusts the distance between the scanning sensor
ON position, and the scanning start position.
Adjusts the distance between the scanning sensor
OFF position, and the scanning end position.
Selects the maximum length of the original that can
be scanned.
442
DP-C405/C305/C265
Function
FEB 2008