It Belt "Cleaning Unit" Replacement - Panasonic DP-C405 Service Handbook

2.19. IT Belt "Cleaning Unit" Replacement

Ver. 1.1
(1) Remove the Cleaning Unit.
1. Remove the IT Belt Unit from the Main Unit.
2. Place a clean sheet of paper (i.e. Ledger or
A3) to catch any toner spill.
3. Remove 2 Black Screws.
4. Remove the Cleaning Unit.
Note:
* For details on maintenance procedure, refer to
the Service Manual
(2) Open the Box, and confirm its contents.
a. Cleaning Unit
b. Cotton Sheet (2)
c. Setting (HYLAR
(You may also use your own Setting Powder)
* Referred to as Setting Powder hereafter.
d. Instructions (This document)
Note:
* Confirm that the printing is in
(The printing on the Old type is in BLUE)
(3) Prepare the Setting Powder
1. Place a clean sheet of paper (i.e. Ledger or
A3).
2. Carefully pour the Drum Setting Powder on
the sheet of paper.
Warning:
Avoid prolonged or repeated breathing of powder
dust particles. In case of inhalation, remove
affected person to fresh air immediately. Avoid eye
contact. In event of contact, flush with water.
Call a physician. Avoid open flames, toxic and
corrosive gases are released during incineration.
103
DP-C405/C305/C265
section 2.2.10., 2.4., and 2.5.
(R)
) Powder* in a plastic bag
RED (New type).
FEB 2008