Table of Contents
Advertisement
Setup Field(s)
Parameter
Move Cursor
Move Cursor To a Character
Move Cursor to Start of Data
Move Cursor Past a Character
Skip Ahead "N" Characters
Skip Back "N" Characters
Send Preset Value
Advanced Data Formatting (MS-1207/MS-2207 Only)
Table 13-1. Setup Field(s) Definitions
Scan the
Move Cursor To Character
, then any printable ASCII character
page 13-28
from the
Alphanumeric
used, the cursor moves to the position after the
matching character. If the character is not there,
the rule fails and ADF tries the next rule.
Scan this bar code to move cursor to the beginning
of the data.
This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is 'A', then
the cursor moves past 'A', 'AA', 'AAA', etc. Scan
the
Move Cursor Past Character
, then select a character from the
13-28
Alphanumeric
there, the cursor does not move (i.e., has no
effect).
Scan one of these bar codes to select the number
of positions ahead to move the cursor.
Scan one of these bar codes to select the number
of positions back to move the cursor.
Send Values 1 through 6 by scanning the
appropriate bar code from
page 9-108. These values must be set using the
prefix/suffix values in
Table A-2 on page
Value 2 = Scan Prefix
Value 1= Scan Suffix 1
Value 3 = Scan Suffix 2
Description
Keyboard. When this is
Keyboard. If the character is not
Prefix/Suffix Values
Table A-1 on page A-1
A-7.
Page
bar code on
13-28
13-28
13-28
bar code on page
13-29
13-30
13-31
on
and
13-27
Advertisement
Table of Contents
