MS-120X and MS-220X Integration Guide
Programmable Raster Height and Raster Expansion Speed
(MS-2204 and MS-2207 Only)
Parameter # E4h, E5h
This parameter selects the laser pattern's height and rate of expansion, and is only used
when Programmable Raster or Always Raster is enabled. This parameter is intended for
very specific applications, and is usually not necessary.
To select the laser pattern's height and/or rate of expansion:
1. Scan the bar code for either Raster Height or Raster Expansion Speed below.
2. Scan two numeric bar codes beginning on
value. Valid values are between 01 and 15.
To change the selection or to cancel an incorrect entry, scan the
9-146.
9-20
Raster Height (Default 15)
Raster Expansion Speed (Default 11)
page 9-144
that represent a two-digit
Cancel
bar code on
page