Advanced Operation; Repeater Operation; Frequency - Yaesu FTM-3200DR Operating Manual

Advanced Operation

Repeater Operation

The FTM-3200DR includes the ARS (Automatic Repeater Shift) function, which permits
communication through repeaters automatically, by simply setting the receiver to the re-
peater frequency.
1. Tune to the repeater frequency.
2. Press the PTT to transmit.
During transmission, radio waves having an 100.0 Hz* tone signal are emitted on the
frequency offset from the receive frequency by 0.6 MHz*.
*: Depends on the transceiver version.
Note: From the Setup Menu, you can change the repeater setting.
RPT ARS 36
RPT FREQ 37 à Allows changing the repeater shift frequency offset.
RPT SFT 38
Checking the Repeater Uplink (Input) Frequency
It is often helpful to be able to check the uplink (input) frequency of a repeater, to see if
the calling station is within direct ("Simplex") range.
To do this, just press the [ REV ( DW )] key. You'll
notice that the display has shifted to the repeat-
er uplink frequency. Press the [ REV ( DW )] key
again to cause operation to revert to normal
monitoring of the repeater downlink (output)
frequency. While listening on the repeater input
frequency using the [ REV ( DW )] key, the repeat-
er offset icon will blink.
20
à Deactivates the ARS function.
à Allows setting the repeater shift direction.
Blinks
FTM-3200DR Operating Manual