Basic Operation; Turning The Transceiver On And Off; Inputting The Call Sign; Adjusting The Audio Volume Level - Yaesu FTM-3200DR Operating Manual

Basic Operation

Turning the Transceiver ON and OFF

1. To turn the transceiver ON, press and hold
the PWR/LOCK key for one second.
2. To turn the transceiver OFF, again press and
hold the PWR/LOCK key for one second.
You can compose any desired Opening Message (up to 8 characters) via Setup Menu
Item "OPEN MSG 27" see page 33 for details.

Inputting the call sign

A screen requesting input of a call sign appears when turning the transceiver on for the
first time, or after resetting the transceiver. The call sign is used to identify the transmit-
ting station when communicating in digital mode.
1. Press the [ V/M ( MW )] key.
2. Rotate the DIAL knob to select characters,
then press the [ V/M ( MW )] .
By rotating the DIAL knob, you can switch
the characters in the following order:
"space" à "-" à "/" à "0" to "9" à "A" to "Z"
r Up to 10 characters (alphanumeric characters including hyphen) can be entered.
r "space", "-", and "/" are not selectable for the first character.
3. Press and hold the [ MHz ( SETUP )] key for one second to save the call sign and exit to
normal operation.

Adjusting the Audio Volume Level

Rotate the VOL knob to adjust the receiver
volume. Clock-wise rotation increases the audio
output level.

Adjusting the Squelch Setting

1. Press the [ SQL ( TXPO )] key, then rotate the
DAIL knob to select the Squelch level.
2. Press the [ SQL ( TXPO )] key again.
Note: A special "RF Squelch" feature is pro-
vided on this radio. This feature al-
lows setting the squelch so that only
signals exceeding a certain S-meter
level will open the squelch. For de-
tails, refer to the Advanced Manual
(download from the Yaesu website).
14
VOL
SQL REV D/A
TXPO D W
VOL
SQL REV D/A
TXPO D W
VOL
SQL REV D/A
TXPO D W
FTM-3200DR Operating Manual
DIAL
M H z V / M
SETUP M W
DIAL
M H z V / M
M W
SETUP
DIAL
M H z V / M
M W
SETUP