23
Troubleshooting
Error
•
Mouse not detected by
system.
•
There is no picture on se-
lected channels / camera
picture is not being
displayed.
•
The system beeps at startup.
•
The system beeps during
motion detection.
•
I am not receiving email
notifications.
#LX400060; r.30328/35049; en-US
Possible Causes
•
Mouse cable is not firmly
connected to the system.
Mouse is not connected to
the system.
•
System needs to be reset
•
Camera cables are loose or
have become disconnected.
•
Motion detection is enabled
and the alarm buzzer is
activated.
•
Email notification is disabled.
•
Send Email setting not en-
abled in Event menu.
Solutions
•
Firmly connect the mouse
cable to one of the USB
ports.
•
Power off the system (dis-
connect power cable). Firmly
connect a USB mouse to
one of the USB ports. Re-
connect the power cable to
the DC 12V port on the rear
panel.
•
Check the camera video ca-
ble and connections.
•
Disconnect and reconnect
the cable at the system and
at the camera.
•
Try moving the camera to an-
other channel or use another
cable.
•
The beep at startup is
normal.
•
Open the Main Menu and
click
>Even-
t>Motion>Motion Detect. Un-
check Buzzer for each
channel and click Apply.
•
Ensure you have configured
email notification. For de-
tails, see 15.3.5 Configuring
Email Alerts, page 55.
•
Make sure that Send Email
is enabled for any events
you want to be notified of.
160