Setting; Network; Selecting Dhcp Or Static Ip Address (Tcp/Ip); Configuring System Ports (Connection) - Lorex LHV2000 Series Instruction Manual

15 Using the Main Menu

15.3 Setting

The Setting menu allows you to configure general system, schedule, network, recording,
display, and motion settings. It also allows you to restore the system to factory defaults.

15.3.1 Network

The Network menu allows you to configure network parameters for your system.

15.3.2 Selecting DHCP or Static IP Address (TCP/IP)

The TCP/IP menu allows you to configure IP address settings.
To configure IP address settings:
1. From the Main Menu, click
2. Under Mode, select DHCP (recommended) to let the system automatically obtain an
IP address from the router or Static to assign a static IP address.
If you select Static, configure the following:
• IP Address: Enter the IP address you would like to assign to the system. Make
sure that no other device on your network is using the same IP address.
• Subnet Mask: Enter the subnet mask for your network.
• Default Gateway: Enter the gateway address for your network.
• Preferred DNS: Enter the address of your primary DNS server.
• Alternate DNS: Enter the address of your secondary DNS server.
3. Click OK to save changes.

15.3.3 Configuring System Ports (Connection)

The Connection menu allows you to configure ports used by the system. Please note that
port forwarding is not required to use FLIR Cloud™ or to connect using the apps.
#LX400060; r.30328/35049; en-US
and then select Network>TCP/IP.
53