Scanning All Tracks On A Cassette (Scan); Changing The Display; Resetting The Counter; Fast Forward/Rewind - Blaupunkt Frankfurt C70 Operating Instructions Manual

Scanning all tracks on a cassette
(SCAN)
Press the soft key 4 with display allo-
cation "SCAN".
"FORWARD" appears on the display. Now you
can listen in briefly to all tracks on the cas-
sette in ascending order.
To stop scanning,
press the soft key 4 with display allo-
cation "SCAN" once again.
The track last scanned then continues to play.
Notes:
The scanning time is adjustable. Please
read the section "Setting the scanning
time" in the chapter "Radio mode".
In order to be able to use the S-CPS,
RPT and SCAN functions, there must
be an interval of at least three seconds
between the individual tracks on the
cassette.

Changing the display

When in cassette mode, you can switch be-
tween the various display modes:
Display of time played ("ELAPSED");
Display of remaining play time
("REMAIN");
Tape counter display ("COUNTER").
Display of the time ("CLOCK").
To switch between the display modes,
press the DIS button : repeatedly until
the desired information appears on the
display.

Resetting the counter

To reset the counter,
press the DIS button : for more than
two seconds.
CASSETTE MODE

Fast forward/rewind

Fast forward
button 7.
Press the
"FORWARD" appears on the display.
Fast rewind
button 7.
Press the
"REWIND" appears on the display.
Stopping fast forward/rewind
Press the OK button 5 or the button
for the opposite direction 7.
Playback is resumed.
Note:
During fast forward/rewind, the radio station
last listened to can be heard. For this, the ra-
dio monitor function must activated.

Switching radio monitor on/off

Press the soft key 4 with the display
allocation "RM".
When radio monitor is switched on, "RM" ap-
pears as an inverse display.
The current status "RM ON" or "RM OFF"
appears briefly on the display when switched
on or off.
Skipping blank sections
(Blankskip)
If blank sections last longer than ten seconds,
you can have them automatically skipped. To
do this, the blankskip function must be acti-
vated.
Activating/deactivating the blankskip
function
Press the soft key 4 with the display
allocation "BLS".
When blankskip is switched on, "BLS" ap-
pears as an inverse display. The current sta-
tus, "BLS ON" or "BLS OFF" appears briefly
on the display when switched on or off.
61