Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Blaupunkt CD70
Summary of Contents for Blaupunkt CD70
- Page 1 Radio / CD Operating instructions...
- Page 2 Open here Ouvrir s.v.p. Por favor, abrir Favor abrir...
- Page 4 button - opens the operating panel Button - switches the radio and mute function on/off Volume control Soft keys - the function of the soft keys depends on the current content of the display OK button - confirms menu entries and leaves the menu DSA button - selects the DSA menu Multifunction rocker switch...
-
Page 5: Table Of Contents
Notes ... 6 Road safety ... 6 Installation ... 6 Accessories ... 6 Guarantee ... 6 International telephone information ... 6 Theft protection, KeyCard ... 7 Inserting the KeyCard ... 7 Removing the KeyCard ... 7 Replacing / “training” KeyCards ... 7 Lost or damaged KeyCards ... - Page 6 RC 08 or RC 10. The RC 10 H remote control is included. All Blaupunkt amplifiers are suitable for use with the radio. The following Blaupunkt CD changers can be connected to the radio: CDC A 06, CDC A 08, CDC A 072 and IDC A 09.
-
Page 7: Notes
Your radio comes with two KeyCards. To replace a lost or damaged KeyCard, con- tact your Blaupunkt dealer. If you use two KeyCards, the settings for the first KeyCard are also used for the second KeyCard. You can, however, store the follow-... - Page 8 To “train” a new KeyCard as a replacement for a lost or unusable KeyCard: Insert the remaining valid KeyCard and switch on the unit. Press the MENU button 8. Press the soft key 4 with the display allocation “KC”. Press the soft key 4 with the display allocation “LRN”.
-
Page 9: Theft Protection, Keycard
Press the soft key 4 with the display allocation “LED” to toggle between “LED ON” and “LED OFF”. To exit the KeyCard menu Press the OK button 5 to go up one level in the menu or press the MENU button 8 to exit the menu. - Page 10 If the unit is being connected for the first time or if the power supply to the unit has been interrupted, the Install menu will appear. The following settings are made in the Install menu: Selection of an external audio source instead of a CD changer Time setting Tuner configuration for US or European...
- Page 11 The system volume can be adjusted in steps from 0 (off) to 50 (maximum). To raise the system volume, turn the volume control 3 to the right. To lower the system volume, turn the volume control 3 to the left. It is possible to adjust the volume that will play when you switch the radio on.
- Page 12 Note: You can adjust the bass, treble and loudness settings separately for each audio source. Press the AUD button 9. “AUDIO 1” appears on the display. Press the soft key 4 with the display allocation “BASS”. button 7 to adjust Press the the bass.
- Page 13 You can adjust the display to your needs and the position of the car radio in your vehicle. Press the MENU button 8. Press the soft key 4 with the display allocation “DISP”. Press the soft key 4 with the display allocation “ANGL”.
- Page 14 This unit is equipped with an RDS radio re- ceiver. Some FM stations broadcast a signal that contains not only the programme, but also information such as the station name and pro- gramme type (PTY). If it is receivable and the RDS function is on, then the station name will appear on the dis- play.
- Page 15 To select the FM or AM frequency range, in radio mode, press the TUNE button >. The Radio Function menu will appear in the display. Press the soft key 4 with the display allocation “FM” for the FM frequency range. Press the soft key 4 with the display allocation “AM”...
- Page 16 You can set the sensitivity of short- and long- range reception separately for AM and FM reception. Press the MENU button 8. Press the soft key 4 with the display allocation “TUN”. Press the soft key 4 with the display allocation “S-LO”.
- Page 17 Select the frequency range and memo- ry bank. Press the soft key 4 with the display allocation of the station name or fre- quency of the desired station. You can scan all receivable stations. The scan time is adjustable within a range of 5-30 sec- onds.
- Page 18 Besides the station name, some stations also broadcast information about the type of pro- gramme that they provide. Your car radio can receive and display this information. Examples of such programme types include: CULTURE TRAVEL SPORT NEWS ROCK CLASSICS You can use the PTY function to specifically select stations that broadcast a certain type of programme.
- Page 19 button 7 to select a Use the programme type. To store a programme type, hold down one of the soft keys 4 with the display allocation of a programme type for longer than one second. The programme type will be saved in the se- lected memory slot.
- Page 20 In the event of poor reception, you can select radio playback in mono. After each time the car radio is switched on, playback is in ste- reo. in radio mode, press the TUNE button >. The Radio Function menu will appear on the display.
- Page 21 buttons 7 to select your Use the character. If a character should remain vacant, select the underline character. button 7 to change the Use the input position. To store the name, press the OK button Press the OK button 5 to return to the previous menu level or the MENU but- ton 8 to leave the menu altogether.
- Page 22 You can use this unit to play standard CDs with a diameter of 12 cm. Generally, so-called CD-Rs (home-recorded CDs) can be played, but due to differences in CD quality, Blaupunkt cannot vouch for per- fect performance. Rewritable CDs (CD-RWs) cannot be played on this unit.
- Page 23 “SCAN” appears briefly on the display. The CD tracks are played in ascending order. Note: The scanning time is adjustable. Read about setting the scanning time in the section “Set- ting the scanning time” in the chapter “Radio mode”. Press the soft key 4 with the display allocation “SCAN”...
- Page 24 In order to clear individual tracks from the list of favourite tracks for a CD, switch on TPM; select the track you wish to clear; hold down the soft key 4 with the dis- play allocation “CLR” for approx. two seconds.
- Page 25 To find out which CD changer is compatible with this unit, please see page 6 of this ma- nual or consult your Blaupunkt dealer. Note: Information on handling CDs, inserting CDs and operating the CD changer can be found in the operating instructions accompanying your CD changer.
- Page 26 To stop the repeat function for the current track or CD, press the soft key 4 with the display allocation “RPT” repeatedly until “RPT OFF” appears briefly on the display. To play the tracks on the current CD in ran- dom order, press the CDC button = while in CD changer mode.
- Page 27 This brings you to the edit mode. If the CD you have selected is not yet known to the unit, seven underlines appear on the display and the current input position flashes. buttons 7 to choose Use the your characters. Should a position re- main blank, you select the underline.
- Page 28 In order to clear individual tracks from the list of favourite tracks for a CD, switch on TPM; select the track you wish to clear; hold down the soft key 4 with the dis- play allocation “CLR” until “TR CLR” ap- pears on the display.
- Page 29 Set the hours using the Once the hours are set, press the button 7. The minutes will blink. Set the minutes using the Press the OK button 5 to return to the previous menu level or the MENU but- ton 8 to leave the menu altogether. The settings are now stored.
- Page 30 This unit is equipped with a digital sound-ad- justment system. This consists of three self- aligning, adaptable 7-band equalisers, a dy- namic noise covering system (DNC) and five sound presets. The three 7-band equalisers (EQ1 - EQ3) are each allocated two channels (left and right). The equalisers EQ1 - EQ3 can be automati- cally lined up with the aid of the microphone supplied.
-
Page 31: Audio Settings
After automatic or manual line-up, press the DSA button 6; select one of the equalisers EQ1, EQ2 or EQ3 using the press the OK button 5. You can preselect sound settings for the fol- lowing musical styles: ROCK JAZZ CLASSIC VOCAL The settings for these musical styles are pre- programmed. - Page 32 Sound impression/problem Bass reproduction too weak Impure bass Booming Disagreeable pressure Sound very dominant, aggressive, no stereo effect Muffled reproduction Low transparency No instrumental brilliance What to do Raise bass with frequency: 64 to 160 Hz, level: +4 up to +6 dB Reduce lower mid-section with frequency: 400 Hz, level: approx.
- Page 33 Dynamic Noise Covering – masking of vehi- cle noise. When your vehicle is in motion, the DNC sys- tem raises the radio volume to the volume you consider pleasant when your vehicle is stationary. The volume is raised depending upon fre- quency ranges and noise development inside the vehicle.
-
Page 34: Pre-Amplifiers
Your car radio has one TMC output for con- nection to Blaupunkt navigation systems. Your Blaupunkt dealer will tell you which naviga- tion systems can be used with your car radio. When a navigation system is connected and a TMC station received, “TMC”... -
Page 35: High-Pass Filter
You can set the frequency and amplifier level for a connected subwoofer. The settings you make depend on the hifi system in your car and the power of your subwoofer. Experiment to find your ideal setting. Press the AUD button 9. Press the soft key 4 with the display allocation “NEXT”. -
Page 36: External Audio Sources
To connect up an external audio source, you will need an adapter cable, obtainable from any Blaupunkt dealer. Hold down the MENU button 8 until the install menu appears on the display. Press the soft key 4 with the display allocation “AUX”. - Page 37 01 610 39 0 015 762 241 026 130 04 41 800-266 25 28 006 535 054 47 042 175 873 212 Blaupunkt-Werke GmbH Bosch Gruppe K7/VKD 8 622 402 514 Fax: 0 51 21 49 40 02 02.525.54.48 014 010 73 20...
- Page 38 Important notice for customers in USA: San Francisco CD70 To ensure that the radio mode on the San Francisco CD70 unit works correctly, the first time you use the radio you have to configure the tuner to receive radio stations in the USA.