Page 3
X-BASS button, X-Bass function CD eject button CD•C button, source selection between CD, radio, CD-changer and AUX (AUX not featured on Dakota CD31) AUDIO button, controls bass, treble, balance and fader Arrow keys MENU button, which calls up the basic settings menu Buttons 1 - 5 <...
Thank you for choosing a Blaupunkt product. We hope you will enjoy your new equipment. Please read these instructions before using for the first time. Blaupunkt’s edi- tors are constantly working to write clear, generally understandable instructions for use. If you still have questions about...
If the device was switched on when the panel was removed, it will switch itself back on automatically with the last set- tings (radio, CD, CD-changer or AUX) as soon as the panel is replaced (no AUX on Dakota CD31).
Page 7
Replace the release panel. The device switches on. The most re- cent settings (radio, CD, CD-changer or AUX) are restored (no AUX on Dakota CD31). Press button > to switch on. To switch off, hold button > pressed for longer than two sec- onds.
Page 8
The volume can be adjusted in steps from 0 (off) up to 66 (maximum). To increase the volume button =. Press the To reduce the volume button =. Press the The volume the device plays at when switched on can be adjusted as follows: Press the MENU button :.
Page 9
If the current operating mode is CD, CD- changer or AUX (only for Santa Fe CD31) Press the BAND button 2. Press the CD•C button 7 until “RADIO” appears in the display. This radio receives stations in the VHF (FM) waveband as well as MW and LW (AM) stations.
Page 10
You can also save the five strongest sta- tions in the area automatically. This is done in the FMT or AM memory level, depending on your chosen waveband. Note: Any stations previously saved on this level will be deleted. Briefly press the TS button 3. Storing starts.
When the setting is complete, press the MENU button :. Note: Once you have changed the regional setting, radio operation begins at the pre-set frequency 87.5 MHz. This device can be used to play stan- dard CDs with a diameter of 5 inches. Danger of damage to CD drive! This device is not suited for playing so-called CD singles (3 inch diame-...
To search rapidly backwards or forwards Hold down one of the 9 until fast searching begins. Press button 4 (MIX) ;. “MIX” appears in the display. The next track is played at random. Press button 4 (MIX) ; again. “MIX” disappears from the display. To listen to a short sample of each track on the CD Press the SCAN button 4.
Page 13
Note: For information on handling CDs, inserting them and operating the CD changer, please consult the op- erating instructions for your CD changer. Press the CD•C button 7 until “CHANGER” appears in the dis- play. Play will start with the first CD that the CD changer recognises.
Page 14
To play the tracks of the current CD in random sequence Press button 4 (MIX) ; briefly. “MIX CD” flashes up, the display shows “MIX”. To play the tracks of all the CDs in the CD changer in random sequence Press button 4 (MIX) ;...
Page 15
To display the time button < briefly. Press the Press the MENU button :. button 9 until Press the “CLOCKSET” appears in the dis- play. button 9. Press the The time is shown in the display. The minutes are blinking, and can be adjusted.
To adjust the bass Press the AUDIO button 8. “BASS” appears in the display. button 9 to ad- Press the just the bass. To adjust the treble Press the AUDIO button 8. “BASS” appears in the display. button 9 until Press the “TREB”...
Instead of the CD-changer, you can connect a different external audio source that has a line output (not for Dakota CD31). Such sources include portable CD, MiniDisc or MP3 players. To connect an external audio source, you need an adapter cable (Blaupunkt No.
If the statutory minimum guarantee pe- riod in your country is less than 12 months, Blaupunkt provides a 12 month manufacturer’s guarantee. Damage caused by wear, incorrect use or use for commercial purposes are excluded from this guarantee.