Handlebar; Removing The Handlebar; Checking The Handlebar; Installing The Handlebar - Yamaha XVS1300A 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
EAS22860

REMOVING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Handlebar grip "1"
NOTE:
Blow compressed air between the handlebar
and the handlebar grip, and gradually push the
grip off the handlebar.
EAS22880

CHECKING THE HANDLEBAR

1. Check:

• Handlebar

Bends/cracks/damage → Replace.
EWA13690
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS22930

INSTALLING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Handlebar "1"
• Front handlebar holders "2"
Front handlebar holder bolt
28 Nm (2.8 m·kg, 20 ft·lb)
ECA3D81006
CAUTION:
• First, tighten the bolts on the lower side of
the front handlebar holder, and then on the
upper side.
email: info@motomatrix.co.uk
• Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
NOTE:
Align the punch mark "a" on the handlebar with
the match mark "b" on the rear handlebar holder.
3. Install:
• Clutch lever "1"
• Clutch cable "2"
Clutch lever bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
NOTE:
Align the mating surfaces of the clutch lever with
the punch mark "a" on the handlebar.
4. Install:
• Left handlebar switch "1"
NOTE:
Align the mating surfaces of the left handlebar
switch with the punch mark "a" on the handlebar.
4-45
HANDLEBAR
2
1
a
b
1
2
a
1 1 1
a