Adjusting The Shift Pedal; Adjusting The Drive Belt Slack - Yamaha XVS1300A 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
EWA13110
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
L LLL L LLL L L LLL L
5. Tighten:
• Brake fluid reservoir bolt
Brake fluid reservoir bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
LOCTITE®
6. Install:
• Sub-fuel tank cover
• Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21380

ADJUSTING THE SHIFT PEDAL

NOTE:
The shift pedal position is determined by the in-
stalled shift rod length "a".
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
255–259 mm (10.04–10.20 in)
2. Adjust:
• Installed shift rod length
M MMM M MMM M M MMM M
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift rod length.
Direction "a"
Installed shift rod length is increased.
Direction "b"
Installed shift rod length is decreased.
email: info@motomatrix.co.uk
L LLL L L LLL L L LLL L LLL
a
M MMM M M MMM M M MMM M MMM
1
c. Tighten the locknuts to specification.
Locknut
8 Nm (0.8 m·kg, 5.8 ft·lb)
d. Make sure the installed shift rod length is
within specification.
L LLL L LLL L L LLL L
EAS21430

ADJUSTING THE DRIVE BELT SLACK

NOTE:
The drive belt slack must be checked at the tight-
est point on the belt.
ECA14950
CAUTION:
A drive belt that is too tight will overload the
engine and other vital parts, and one that is
too loose can skip and damage the swing-
arm or cause an accident. Therefore, keep
the drive belt slack within the specified lim-
its.
NOTE:
Measure the drive belt slack when the engine is
cold, and when the drive belt is dry.
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on the sidestand and or on a
suitable stand so that the rear wheel is elevated.
2. Check:
• Drive belt slack "a"
Out of specification → Adjust.
3-23
CHASSIS
a
1
2
b
L LLL L L LLL L L LLL L LLL