Checking The Piston Pins - Yamaha XVS1300A 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
a. 10 mm (0.39 in)
3. Measure:
• Piston ring end gap
Out of specification → Replace the piston
ring.
NOTE:
The oil ring expander spacer end gap cannot be
measured. If the oil ring rail's gap is excessive,
replace all three piston rings.
Piston ring
Top ring
End gap (installed)
0.20–0.35 mm (0.0079–0.0138
in)
Limit
0.60 mm (0.0236 in)
2nd ring
End gap (installed)
0.45–0.60 mm (0.0177–0.0236
in)
Limit
0.95 mm (0.0374 in)
Oil ring
End gap (installed)
0.20–0.70 mm (0.0079–0.0276
in)
EAS24440

CHECKING THE PISTON PINS

The following procedure applies to all of the pis-
ton pins.
1. Check:
• Piston pin
Blue discoloration/grooves → Replace the
piston pin and then check the lubrication sys-
tem.
2. Measure:
• Piston pin outside diameter "a"
Out of specification → Replace the piston pin.
email: info@motomatrix.co.uk
CYLINDERS AND PISTONS
Piston pin outside diameter
22.991–23.000 mm (0.9052–
0.9055 in)
Limit
22.971 mm (0.9044 in)
3. Measure:
• Piston pin bore diameter "b"
Out of specification → Replace the piston.
Piston pin bore inside diameter
23.004–23.015 mm (0.9057–
0.9061 in)
Limit
23.045 mm (0.9073 in)
4. Calculate:
• Piston-pin-to-piston-pin-bore clearance
Out of specification → Replace the piston pin
and piston as a set.
• Piston-pin-to-piston-pin-bore clearance =
Piston pin bore diameter "b" -
Piston pin outside diameter "a"
Piston-pin-to-piston-pin-bore
clearance
0.004–0.024 mm (0.0002–0.0009
in)
5-36