Installing The Crankshaft Assembly - Yamaha XVS1300A 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
d
4. Tighten:
• Connecting rod nuts
M MMM M MMM M M MMM M
EWA3D81005
WARNING
• Replace the connecting rod bolts and nuts
with new ones.
• Clean the connecting rod bolts.
NOTE:
Tighten the connecting rod bolts using the fol-
lowing procedure.
a. Tighten the connecting rod bolts to specifica-
tion with a torque wrench.
Connecting rod bolt (1st)
15 Nm (1.5 m·kg, 11 ft·lb)
b. Put a mark "1" on the corner of the connecting
rod bolt "2" and the connecting rod cap "3".
c. Tighten the connecting rod bolts further to
reach the specified angle 125–135°.
Connecting rod bolt (final)
Specified angle 125–135°
email: info@motomatrix.co.uk
c
M MMM M M MMM M M MMM M MMM
EWA3D81006
WARNING
When a bolt is tightened more than the spec-
ified angle, do not loosen and then retighten
it.
Replace the bolt with a new one and perform
the procedure again.
ECA3D81012
CAUTION:
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angle.
L LLL L LLL L L LLL L
EAS26210
INSTALLING THE CRANKSHAFT
ASSEMBLY
1. Install:
• Crankshaft assembly
ECA3D81013
CAUTION:
To avoid scratching the crankshaft and to
ease the installation procedure, lubricate
each bearing with engine oil.
NOTE:
Align the right connecting rod with the rear cylin-
der sleeve hole.
5-78
CRANKSHAFT
L LLL L L LLL L L LLL L LLL