Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
EAS21080
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the ex-
haust pipes and gaskets.
1. Check:
• Front cylinder exhaust pipe "1"
• Rear cylinder exhaust pipe "2"
• Muffler "3"
Cracks/damage → Replace.
• Gaskets "4"
• Gaskets "5"
Exhaust gas leaks → Replace.
2. Check:
Tightening torques
• Exhaust pipe nuts "6"
• Front cylinder exhaust pipe and rear cylinder
exhaust pipe bolt "7"
• Muffler and rear cylinder exhaust pipe bolt "8"
• Muffler bracket and frame bolts "9"
• Muffler bracket and muffler bolts "10"
Exhaust pipe nut
20 Nm (2.0 m·kg, 14 ft·lb)
Front cylinder exhaust pipe and
rear cylinder exhaust pipe bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
Muffler and rear cylinder exhaust
pipe bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
Muffler bracket and frame bolt
53 Nm (5.3 m·kg, 38 ft·lb)
Muffler bracket and muffler bolt
35 Nm (3.5 m·kg, 25 ft·lb)
2
5
3
8
10
(3)
email: info@motomatrix.co.uk
4
New
New
4
6
1
7
5
9
EAS21110
CHECKING THE COOLANT LEVEL
1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
2. Check:
• Coolant level
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add the
recommended coolant to the proper level.
NOTE:
To add coolant, remove the coolant reservoir
cap cover "1" and coolant reservoir cap "2".
6
3-15
ENGINE
a
b
1
2