Handlebar Switches - Yamaha EXCITER 2024 Owner's Manual

Instrument and control functions

Handlebar switches

Left
1
2
5
3
1. Dimmer/Pass switch "
2. Turn signal switch " /
3. Horn switch " "
Right
1 2 3
1. Engine stop switch "
2. Hazard lights switch "
3. Start switch " "
EAU1234T
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, push the
switch down towards "PASS" while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
/ /PASS"
ter position. To cancel the turn signal
"
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to "
of an emergency, such as in the event
/ "
of an overturn or if the throttle is stuck.
/
"
/ /PASS"
" for the high
" for the low beam.
/ "
". To signal a left-hand
". When
"
/ "
" (run) before
" (stop) to stop the engine in case
5-7
EAU54203
Start switch " "
Push this switch to crank the engine
with the starter. See page 7-2 for start-
ing instructions prior to starting the en-
gine.
Hazard lights switch " /OFF"
EAU12461
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
EAU12501
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12664
gine not running, otherwise the bat-
tery may discharge.
EAU12713
EAUN2211
ECA10062