Auto Job Release; Auto Print; Printer Lockout Duration - Xerox Versant 2100 Press System Administration Manual

Common Service Settings

Auto Job Release

If an error occurs during a copy or scan job, you can set the time that elapses until the
current job is automatically cleared, and thereby enabling the completion of the next
job. Errors that may occur include a paper feed, a jammed original, a copy jam, running
out of hard disk space, etc. Once the current job is cleared, jobs that can be continued
are limited to those that only use parts of the machine not affected by the error. Set
the value in the range 4 to 99 minutes, in 1 minute increments. Select Off if you do not
want to use this feature.
1. From the Machine Clock/Timers window, select Auto Job Release, and select Change
Settings.
2. Select Off or On.
3. If you selected On, set the time using the arrows or the numeric keypad to enter a
numeric quantity.
4. Select Save to save the settings and return to the previous window.

Auto Print

Use this option to set the time between when the press returns to a Ready state and
when the press begins printing. When set for On, select a time period between 1-240
seconds, in one second intervals. If you select Off, printing starts immediately, once the
press is ready.
1. Select Machine Clock/Timers.
2. From the Machine Clock/Timers window, select Auto Print, and then select Change
Settings.
3. Select Off or On.
4. If you selected On, set the time by using the arrows, or the numeric keypad to enter
a numeric time.
5. Select Save to save the settings and return to the previous window.
6. Select Close and, if needed, log off Administrator mode.

Printer Lockout Duration

Use this option to set the press to not print jobs temporarily or for a set period of time.
When this Lockout feature is On, define the time from the start to the end of the printing
lockout. Set the values from 0 to 23 hours and to 59 minutes. If you select Off, no printing
lockout occurs and printing is not disabled.
1. Select Machine Clock/Timers.
2. From the Machine Clock/Timers window, select Printer Lockout Duration, and then
select Change Settings.
3. Select Off or On.
4. If you selected On, set the Start and End time by using the arrows, or the numeric
keypad to enter a numeric quantity.
5. Select Save to save the settings and return to the previous window.
6. Select Close and, if needed, log off Administrator mode.
6-6 Xerox ® Versant 2100 Press
System Administration Guide