Fitting The Unit On The Bracket - Heat Controller RPHE-093G Series Installation & Operation Manual

Heat Controller, Inc.
2. INSTALLATION

2.7 FITTING THE UNIT ON THE BRACKET

(P11, P12)
After checking again that the fastening bracket is
securely fastened to the wall, and that any
necessary preparations for electric connection
and condensate drainage have been made,
fasten the unit to its supporting bracket.

Lift up by holding the sides at the bottom.

Tilt the unit slightly toward you to engage the
unit with the bracket flange.

The unit can now be pushed firmly against
the wall.
Carefully inspect the installation to make sure that
the insulated back panel fits firmly against the
wall, there are no gaps at the back of the unit and
wall, and that the two plastic semicircles on the
back side of the unit are placed inside of the two
plastic pipes fixed inside the wall.
...........................................................................................................................
OWNER'S MANUAL
8
Packaged Thru-The-Wall Heat Pump
The unit shall not be installed inside a laundry
room.
The unit must be positioned so that the plug is
accessible.
The unit shall be installed in accordance with the
National Electrical Code N.E.C. (C.E.C. in
Canada) and any other local ordinances.