Introduction - Heat Controller RPHE-093G Series Installation & Operation Manual

Packaged Thru-The-Wall Heat Pump
1. GENERAL INFORMATION

1.1 INTRODUCTION


Do not dispose of any packaging until
installation of the unit is completed.

After having removed the packing, check
that all the contents are intact and complete.
See list of accessories. In the event of
missing parts, contact your retailer.

This unit has been designed to heat or cool
the air of a room and should only be used for
this purpose.

The manufacturer cannot be held liable for
damage caused to property or injury to
persons or animals due to incorrect
installation, regulation and maintenance or
improper use.

This unit contains R410A refrigerant. At the
end of its life, the disposal of this unit must
be in accordance with the regulation
governing the recycling of this product.
Please contact your local authority for
regulatory advice.

Do not switch on before having totally
assembled the unit and before installing in
its correct operating position.

Before starting the appliance, check that it is
correctly earthed, according to the
legislation in force in the country concerned.
1.2 IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety
precautions should always be followed:

Do not place objects on the product or allow
objects to obstruct the inlet or outlet
openings.

Extreme care should be taken when any
product is used by, or near children and
pets, and whenever the product is left
operating and unattended.

Before operating the product remove the unit
from its packaging and check it is in good
condition.

Do not operate any product with a damaged
cord or plug, or after the unit malfunctions,
has been dropped, or damaged in any
manner.
1. GENERAL INFORMATION
...........................................................................................................................
OWNER'S MANUAL

Do not pull, remove or twist the power cord,
even if disconnected from the main electrical
supply.

Never place the power cord under a carpet
or rug or other location where it creates a
tripping hazard.

Do not attempt to repair or adjust any
electrical or mechanical functions on this unit
as this may void warranty.

Always operate the product from a power
source of the same voltage, frequency and
rating as indicated on the product
identification plate.

This unit is not intended for use in wet or
damp locations.

Do not place the unit near an open flame,
cooking or heating appliance, or hot surface.

Do not operate the unit in areas where
gasoline or other flammables are used or
stored.

Do not carry out any cleaning or
maintenance or access internal parts until
the unit has been disconnected from the
main electrical supply.

Do not alter the safety or regulating devices
without the permission and instructions of
the manufacturer.

Repair or maintenance work must be carried
out by an authorized servicer in compliance
with the instructions given in this booklet.

Do not alter the appliance. Since
hazardous situations could be created, the
manufacturer of the appliance will not be
liable for any damage or injury caused.

This instruction booklet is an integral part of
the appliance and should therefore be
carefully preserved and always accompany
the appliance in the event of transfer to
another owner or another installation.
1
Heat Controller, Inc.