Fitting The Gratings - Heat Controller RPHE-093G Series Installation & Operation Manual

Packaged Thru-The-Wall Heat Pump
2.6 FITTING THE GRATINGS AND THE METAL
GRILLE (P7, P8, P9, P10)
To fit the external two gratings and the metal grille,
please proceed as follows:

Familiarize yourself with the fitting of the
flexible grating and the metal grille to the
tube before installation.

Insert the cords through the centre of the
grating. Note: The flexible grating fits on
the outside of the tube and the metal grille
fits inside.

Insert the supplied cord into the hole in the
center of the metal grille (see P9). Then
insert the supplied cord into the hole in the
center of the grating (see P9). Fold the outer
grating in half grasping the cord with your
free hand. Insert your arm inside the pipe
with the grating and push all the way to the
outside. Let the grating unfold and pull the
cord toward you.

With a little patience and manipulation, the 2
gratings will fit the end of the tubes.

Grasping the cord, insert your fingers
between the fins and pull the grating toward
you until it is properly fitted to the pipe,
keeping the fins in vertical position. Then
tighten the cord and fasten it to the dent on
the internal flanges (see P10).
...........................................................................................................................
OWNER'S MANUAL
2.6 FITTING THE GRATINGS AND THE METAL
GRILLE (P7, P8, P9, P10) – CONT'D

If the external grating is accessible, to
prevent its removal, it is recommended to
fasten it to the wall with wall plugs and Ø1/4"
screws.

Once the grating is secure, slide the metal
grille inside the air discharge and the air
intake hose (1 per each hose) along the
cord.

Once the metal grille is adjacent to the
grating, use one of the special butterfly nut
screws provided to secure the metal grille to
the cord.
7
Heat Controller, Inc.