Set Lengths For Discrete 2 Of 5 - Symbol Cyclone M2000 Series Product Reference Manual

Set Lengths for Discrete 2 of 5

Lengths for D 2 of 5 may be set for any length, one or two discrete lengths, or lengths within
a specific range. The length of a code refers to the number of characters (i.e., human
readable characters) the code contains, and includes check digits. See
A-8 for ASCII equivalents.
• One Discrete Length - This option allows you to decode only those codes
containing a selected length. For example, if you select D 2 of 5 One Discrete
Length, then scan 1, 4, the only D 2 of 5 symbols decoded are those containing
14 characters.
• Two Discrete Lengths - This option allows you to decode only those codes
containing two selected lengths. For example, if you select D 2 of 5 Two Discrete
Lengths, then scan 0, 2, 1, 4, the only D 2 of 5 symbols decoded are those
containing 2 or 14 characters.
• Length Within Range - This option allows you to decode a code type within
a specified range. For example, to decode D 2 of 5 symbols containing between 4
and 12 characters, first scan D 2 of 5 Length Within Range. Then scan 0, 4, 1 and
2 (single digit numbers must always be preceded by a leading zero).
• Any Length - Scanning this option allows you to decode D 2 of 5 symbols
containing any number of characters.
Numeric bar codes begin on
selection, scan the
page 3-130. If you make an error, or wish to change your
Cancel bar code on page 3-132.
Parameter Menus
Table A-4 on page
3-71