Grizzly G1023RLX Owner's Manual page 75

12. Loosen the set screws shown in Figure 131.
Figure 131. Location of arbor set screws.
13. Use a punch and hammer to drive the arbor
out, as shown in Figure 132. Have another
person catch the arbor so it does not drop
and become damaged.
Figure 132. Removing arbor.
14. Pivot the motor up, tighten the motor bolt,
then remove the belt from the top and bottom
pulleys.
15. Remove the rear spacer from the bearing
housing (see Figure 133).
Rear
Spacer
Figure 133. Location of rear spacer.
Model G1023RL Series (Mfd. Since 12/11)
Set Screws
16. Tap the rear arbor bearing out; make sure
another person catches the bearing.
17. Remove the key and the larger front spacer
from the arbor and set these aside.
18. Place the arbor in a vise, as shown in Figure
134, with the vise teeth clamping the bearing,
then use a soft rubber hammer to force the
arbor out of the bearing.
Arbor
Figure 134. Removing arbor bearing.
19. Slide a new 6203-2RS ball bearing, part
P1023RL100, onto the arbor shaft, then
place the arbor between the vise teeth, as
shown in Figure 135.
Arbor
Figure 135. Seating arbor into new bearing.
20. Using the rubber hammer, seat the arbor onto
the bearing (see Figure 135), then remove it
from the vise.
Bearing
Bearing
-73-