Grizzly G1023RLX Owner's Manual page 43

Cutting Rabbets with a Standard
Blade
A ripping blade is typically the best blade to use
for cutting rabbets when using a standard blade
because it removes sawdust very efficiently. (See
Page 29 for blade details.) Also, a sacrificial fence
is not required when cutting rabbets with a stan-
dard blade.
To cut rabbets with the standard blade:
1. DISCONNECT SAW FROM POWER!
2. Ensure that the riving knife and standard
table insert are installed. Or install the option-
al Model H4231 zero clearance insert, mak-
ing sure the center section of the insert has
already been removed—so the blade can be
raised correctly in the following steps.
3. Mark the width of the rabbet cut on the edge
of the workpiece, so you can clearly identify
the intended cut while it is laying flat on the
saw table.
4. Raise the blade up to the desired depth of cut
(depth of rabbet channel desired).
5. Stand the workpiece on edge, as shown in
Figure 60, then adjust the fence so the blade
is aligned with the inside of your rabbet chan-
nel.
Blade
Figure 60. Rabbet cutting with a standard blade.
— If the workpiece is very tall, and is unstable
when placed against the fence, lay it flat on
the table and use a dado blade to perform
the rabbet cut.
Model G1023RL Series (Mfd. Since 12/11)
DO NOT place a tall board on edge to per-
form a rabbet cut with a standard blade.
Workpieces that are too tall to properly sup-
port with the fence can easily shift during
operation and cause kickback. Instead, place
the stock flat on the saw and perform the
rabbet cut with a dado blade, as instructed
on Page 40.
6.
7.
Fence
Reconnect the saw to the power source, then
perform the cut.
Lay the workpiece flat on the table, as shown
in Figure 61, adjust the saw blade height to
intersect with the first cut, then perform the
second cut to complete the rabbet.
Blade
Workpiece
Figure 61. Second cut to create a rabbet.
Fence
-41-