Grizzly G1023RLX Owner's Manual page 62

5.
Open the motor cover, loosen the jam nut
shown in Figures 99–100, adjust the stop
bolt up or down according to how far off the
blade was from 90°, then repeat Steps 2-3
until the blade stops at 90°.
Blade Angle
Trunnion
90° Stop Bolt
& Jam Nut
Figure 99. 90° stop bolt and jam nut.
Figure 100. 90° stop bolt and jam nut (table
removed for clarity).
6. Tighten the jam nut, then close the motor
cover.
-60-
90° Stop Bolt
& Jam Nut
Setting 45° Stop Bolt
1.
DISCONNECT SAW FROM POWER!
2.
Raise the blade as high as it will go, then tilt it
towards 45° until it stops and cannot be tilted
any more.
3. Place a 45° square against the table and
blade so it contacts the blade evenly from
bottom to top, as shown in Figure 101. Make
sure a blade tooth does not obstruct the
placement of the square.
Blade
Table
Figure 101. Checking blade at 45°.
—If the blade is 45° to the table, then adjust-
ments do not need to be made.
—If the blade is not 45° to the table, you will
need to adjust the 45° stop screw. Proceed
to the next step.
Model G1023RL Series (Mfd. Since 12/11)
45° Square