Suspension; Removal - Yamaha SRX440 1980 Service Manual

5-3. SUSPENSION
A. Removal
1. Remove the two front pivot shaft
mounting bolts and four rear pivot shaft
mounting bolts.
1980 SRX440
Wear limit: 10 mm (0.4 in)
Slide runner securing screw tightening
torque:
4.5 Nm (0.45 m-kg)
(
~m
@J
=--t
.
1. Wear limit: 10 mm (0.4 in)
2. New: 15 mm (0.6 in)
2. Remove the slide rail suspension
assembly.
B. Inspection
1. Check to see if slide runners are worn
excessively. If the slide runner thickness
is less than specified value. replace slide
runner.
5-17
2. Check the suspension wheel for
damage.
3. Shock absorber
WARNING (Rearshock):: ......,
This shock absorber contains highly
pressurized nitrogen gas.
Read and understand the following in-
formation before handling the shock ab-
sorber. The manufacturer cannot be
held responsible for property damage or
personal injury that may result from im-
proper handling.
1) Do not tamper with or attempt to
open the cylinder assembly. Injury
may result.
2) Do not subject shock absorber to an
open flame or other high heat. This
may cause the unit to explode due to
excessive gas pressure.